Garage Door Photo Eye Height

To test the safety eye system start the door closing then use a controlled obstruction to.

Garage door photo eye height.

The photo eye sensors on garage doors are located about six inches above the ground one on either side of the garage door. One of the sensors directs a beam toward the other. The way they function is quite simple. 6 inches of the path of the door.

The sensors should be symmetrical in this height for the light beams to work properly. If an object interrupts the beam. The photo eye consists of two sensors one on either side of the garage door about 6 inches above the ground. The photo eyes mentioned above should not be installed higher than six inches above the garage floor.

Some diy homeowners are not sure as the the correct height of these electronics eyes. When the beam is broken the garage door movement should reverse. This is so that any small children or pets will not be hurt if they are in the way of the door. Break the safety eye beam.

These sensors send out an invisible beam that connects them. If the eyes are installed higher a person or pet could get under the beam and not be detected by the photo eyes thus the standard manufacturer s recommendation of 4 to 6 above the floor. It is recommended that the safety eye sensors be tested monthly on all commercial and residential.